Installation and maintenance
Installing the system in an upright position (right side up)
The TDC Sunrise is mainly used for party lighting and can be placed directly on a flat surface such as a table
or counter. Please ensure that the device is positioned safely and the power cord is installed properly.
Accidents may happen if the power cord is hanging freely and can be pulled by small children, causing the
device to fall down. Install the device securely and contact your local dealer or a skilled technician for the
best installation advice for permanent and mobile setups.
Installing the fixture in a suspended position (inverted)
The TDC Sunrise is equipped with mounting brackets, which makes it possible to install the device on a
ceiling, wall or beam. Mounting hardware is not included, but is available at your local hardware store. Make
sure to select the right mounting hardware for the material. For example: wooden beams require other
hardware than a brick wall. Please ensure that at least one mounting point per side is used to mount the light
effect.
The TDC Sunrise was not designed to be installed directly to a T-bar or truss system. If you want to do so,
please ask your local dealer for advice on the best installation options for your application. Couplers can be
mounted to the brackets of the TDC Sunrise, but make sure to select the right couplers and mounting gear to
ensure a proper fit.
Lens mechanism
The TDC Sunrise is equipped with a transparent dome with integrated lens optics. Looking directly into the
lens from a short distance is not recommended, as the human eye will adjust to the brightness, possibly
causing temporary visual blind spots. These will disappear after a short period of time, and will not cause
permanent damage to the eye or permanent loss of vision, but can cause disorientation and inconvenience.
Spare parts
This unit has no user-serviceable parts inside. If any damage to internal components occurs, contact your
local dealer or a specialised technician in order to repair the fixture.
Cleaning:
Clean the housing of the fixture frequently with a damp cloth, to remove dust and/or dirt.
WARNING:
Always disconnect the fixture from your wall outlet or other power supply and let the fixture dry
before reconnecting it. This prevents possible electric shocks.
The lenses can be cleaned with a non-aggressive glass cleaning solution, but this is not recommended. Ayra
advises cleaning the mirror and lens with a fine brush, while removing dust and/or dirt with a vacuum cleaner.
Avoid touching the lenses with your bare fingers, to prevent fingerprints on the optics.
Check-up
To prevent hazardous situations, make sure your fixture is in optimal condition before using it. Check your
fixture frequently by using the following check list:
- All screws must be mounted securely.
- Check all screws and metal parts for corrosion. There shouldn't be any visible signs of corrosion.
- The exterior of your fixture must be in optimal condition. Check your fixture for dents, cracks or missing
parts.
- Your installation spot must be in optimal condition. Check your installation spot for corrosion, cracks, dents
and strength.
- Electrical components (connectors and cables) must be in optimal condition. No form of damage (cuts,
exposed wire cores or any other irregularities) should be visible.
If any visual or mechanical damage is detected, contact your local dealer or a specialised technician. Do not
use a damaged or malfunctioning fixture.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 28-10-2015 RV Revision date + author initials: -
