of your DMX chain
Signal loss or distortion in DMX
values
Insert a DMX booster in your DMX
chain after 32 fixtures or less. After
a maximum of 32 fixtures the DMX
signal needs to be refreshed.
The fixture does not respond to all
DMX channels
Wrong DMX channel mode
Check the DMX channel mode of
the fixture. If the wrong value is
set, change the channel mode to a
different setting and try again.
The pan and tilt of the fixture does
not respond to DMX commands
properly
Movement speed set too high in
15CH DMX mode
Decrease the movement speed
value so the speed increases.
Programming of the fixture is not
optimal
If the movement values switch
directly from value 000 to 255 and
back in a program and the speed
is set too high, it may be possible
that the fixture can not keep up
physically. Decrease the speed or
try to adjust your programming.
I can not switch working modes
Fixture set to slave mode
Enter the menu and adjust the
Master-slave function to Master if it
is set to Slave 1 or 2. During
operation as Slave, it is not
possible to activate the automatic
or music controlled modes.
Fans make too much noise
Adjust fan settings
If the fans make too much noise
for your purpose, it is possible to
adjust the fan speed through the
menu. It is recommended to use
the automatic fan speed mode so
the cooling is regulated
automatically. For theatrical
purposes, the fans can be turned
off. The built-in temperature
protection has to be enabled if you
switch the fans off.
Fan does not turn on
Auto mode, temperature controlled The fan will spin for some seconds
during startup. If the automatic fan
control mode is used, the fan will
only turn on if needed to cool the
head or body of the device. When
the temperature of the fixture
increases, the fan will start cooling
slowly.
All information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 1.0
Creation date + author initials: 13-05-2015 RV Revision date + author initials: