Complete * Schaumburg, IL 60173 *
Phone:
888
-
392
-
9947
6
OPERATING INSTRUCTIONS
Loading fasteners
Press the latch mechanism and slide back the magazine unit.
Load fasteners into the magazine.
Close the magazine.
Type of actuating and trigger system
No Safety:
This model stapler is not equipped with a safety. When you pull the trigger a single staple, or
series of staples will be fired. Always point the stapler towards your work piece.
Operating procedures
Protective equipment:
before using any tool always ensure that you and those in the work area are using the
appropriate working equipment, including safety goggles.
Firing a fastener:
to fire a fastener hold the nose of the tool against the work piece, then pull the trigger to fire
a fastener. By pulling the trigger half
-
way a single shot is fired. Full trigger will activate the automatic firing
setting, until released.
Adjusting Speed:
use the dial on side of trigger to adjust how fast or slow the staples are fired.
Always use the lowest possible air pressure for the following reasons,
-
save energy
-
less noise will be produced
-
a reduction in fastener driving tool wear will be achieved
Any defective or improperly functioning tool must be immediately disconnected from the compressed air
supply and passed to a specialist for inspection.