Complete * Schaumburg, IL 60173 *
Phone:
888
-
392
-
9947
4
SAFETY INSTRUCTIONS
Use safety glasses:
all persons in the work area must always wear safety glasses in order to prevent eye
injuries.
Ear protection
must also be worn to prevent a possible hearing loss.
Use clean dry regulated compressed air
at the recommended pressure (given in the technical data).
Use only fasteners
according to manufactures technical data.
Never
exceed the maximum recommended operating pressure of this tool.
Never
use oxygen, carbon dioxide, combustible gases or any bottled gas as a power source.
Always disconnect
the air supply when doing any tool maintenance, clearing a jam, moving location, leaving
the work area or passing the tool.
Regularly inspect
the safety, the trigger and the springs for free unhindered movement, never use a tool that
requires servicing.
Connect
the male free flow nipple to the tool side of the air line so that the tool is depressurized when
disconnected from the hose.
Never
load fasteners with the trigger safety depressed, it will result in a fastener being fired.
Never
carry the tool with the safety depressed, if bumped it will result in a fastener being fired.
Never
point the tool at yourself or at any one else.
Never
fire a fastener into a hard brittle surface such as concrete, steel or tiles.
Do not drive
fasteners too close to an edge or at too great an angle as the fastener may fly free or ricochet
causing personal injury and damage.
Always
ensure that the work area is amply lit so as to avoid possible accidents.
Never
remove, tamper with or otherwise cause the tools operating controls to become inoperable.
