XSVI-6523-NAV
3
Installing the XSVI-6523-NAV
Initializing the XSVI-6523-NAV
With the key in the off position:
• Connect the XSVI-6523-NAV harness into the interface, and then to the harness in
the vehicle.
Note:
For the Fiat 500L and Ram Promaster City, do not connect the harness to the
vehicle yet.
Note:
If using the ASWC-1, connect it after you initialize and test the XSVI-6523-NAV,
with the key in the off position.
Attention!
If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an ASWC-1 connect it after you initialize and test the
interface/radio, with the key in the off position.
For the Fiat 500L and Ram Promaster City:
• Turn the hazard lights on.
• Connect the XSVI-6523-NAV harness to the wiring harness in the vehicle.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio
comes on.
Note:
If the radio does not come on within 60 seconds, turn the key to the off
position, disconnect the interface, check all connections, reconnect the interface,
and then try again.
• Turn the key to the off position, and then to the accessory position. Turn off the
hazard lights. Test all functions of the installation for proper operation, before
reassembling the dash.
For all other models:
• Turn the key (or push-to-start button) to the ignition position and wait until the radio
comes on.
Note:
If the radio does not come on within 60 seconds, turn the key to the off
position, disconnect the interface, check all connections, reconnect the interface,
and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions
of the installation for proper operation, before reassembling the dash.
