XSVI-6523-NAV
2
Connections to be made
From the XSVI-6523-NAV harness to the aftermarket radio:
• Connect the
Black
wire to the ground wire.
• Connect the
Yellow
wire to the battery wire.
• Connect the
Red
wire to the accessory wire.
Note:
If installing an ASWC-1 (sold separately), there will be an accessory wire there
to connect as well.
•
For the Fiat 500L only:
Connect the
Blue/White
wire labeled “500L amp turn on” to the
amp turn on wire. This wire must be connected to hear sound from the factory amplifier
.
•
For all models except the Fiat 500L:
Connect the
Blue/White
wire to the amp turn
on wire. This wire must be connected to hear sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the
Orange
wire to it.
• Connect the
Gray
wire to the right front positive speaker output.
• Connect the
Gray/Black
wire to the right front negative speaker output.
• Connect the
White
wire to the left front positive speaker output.
• Connect the
White/Black
wire to the left front negative speaker output.
• Connect the
Green
wire to the left rear positive speaker output.
• Connect the
Green/Black
wire to the left rear negative speaker output.
• Connect the
Purple
wire to the right rear positive speaker output.
• Connect the
Purple/Black
wire to the right rear negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the
Blue/Pink
wire to the VSS/speed sense wire.
• Connect the
Green/Purple
wire to the reverse wire.
• Connect the
Light Green
wire to the parking brake wire.
• If retaining the factory backup camera, connect the
Yellow
RCA jack to the backup
camera input.
• If retaining the factory AUX-IN jack, connect the
Red
&
White
RCA jacks to the AUX input.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for radio
connections and programming.
Note:
Disregard the harness that comes with the ASWC-1.
• Connect the
Red
wire to the accessory wire.
