23
Setting up the Machine
A
G
F
5mm
Fig 59
Adjusting the feeder roller & ant-kickback assembly
Fig 61
Fig 60
Loosen the feeder roller clamping knobs (
a
and
b
) & move the feeder roller to the centre of the workpiece,
tighten the clamping knobs. Undo the anti-kickback clamping knobs (
c
and
d
) and move the assembly near the
workpiece, tighten the clamping knob
(c)
, raise the assembly so the steel plate is about 5-10mm above the work
table (See figs 60 & 61).
b
c
d
5-10mm
Fig 62
Fig 63
Leveling the sliding table
Place a level between the sliding table & work table & check that both tables are level. If not loosen the three nuts
(e) beneath the sliding table and adjust the two coach bolts (f ), until the bubble on the level is between the two
markers (g), tighten the three nuts (e) (See figs 62 & 63).
E
Summary of Contents for WS1000TA
