Axminster WS1000TA, User Manual

Page: 24 / 44

24
Installing/Changing the Spindle Moulder Cutter
Changing the spindle moulder cutter
Fig 66 Fig 67
Raise the spindle to the maximum height by unlocking the spindle moulder rise/fall locking handle and turning
the spindle moulder rise/fall handle clockwise then lock in place. Using a 19mm spanner remove the bolt &
clamping block
(D) , spacing collar/s (E) and clamping washer (F ) and place them safely aside, remove the cutter
block. Check the new cutter block for damage,sharpness etc. Fit the new cutter block on the arbor as low as
possible, see fig 1and 2. Watch the direction of rotation (counter-clockwise) when mounting the cutter. replace
the clamping washer
(F) , spacing collar/s (E) , clamping block (D) and bolt. Tighten the clamping block securely
(See figs 64,65,66 &67).
Turn the cutter block once by hand to check it doesn't foul anywhere. Reconnect the machine to the mains
supply. Give the machine a 'quick' burst check
( i.e. quick ON-OFF) to ensure everything is O.K. If everything is
satisfactory, continue to use the machine. Check the old cutter block for damage, sharpness, resin buildup, etc.,
clean if necessary and send for refurbishment/resharpening if required. If the cutter block is not to be
re-sharpened, clean and pack away in its stowage case.
Spindle
(arbor)
19mm Spanner
Fig 64
Fig 65
E
E
F
F
E
D
D
Cutter block
The cutter block must
be positioned on the
arbor as low as
possible. (See fig A)
Fig A
Fig B
DISCONNECT THE MACHINE FROM THE MAINS SUPPLY!