09
Axminster Junior Chuck...
AXMINSTER
JUNIOR
The Axminster Junior chuck is the first true collet chuck to
be produced with woodturners specifically in mind. In this
chuck we use our successful ER engineering collets
which are precision machined to grip evenly along their
whole length without marking the work. The chuck is
supplied with three collets: 6 to 7mm, 10 to 11mm and 12 to
13mm and there is a range of additional ones available which
together give a gripping range from 1mm to 13mm diameter.
The collet is tightened by means of a nut which has both a knurled
section and spanner flats to give two tightening options. The Junior chuck
has been designed with the miniaturist in mind and its ability to handle long lengths of dowel (in
conjunction with a hollow headstock) make it particularly useful for repeat production of small items.
These stepped jaws fit into the chuck
in place of the accessory mounting
jaws to provide a selection of
internal and external parallel
gripping surfaces. They can be used
on the Axminster Super Precision Chuck,
as well as the Clubman, the Woodturner’s
or the Carlton chucks.
Axminster Internal and External Jaw Set...
Accessory Mounting Jaws...
Order no: 701004 T01 3/4" x 16tpi
Order no: 701005 T04M 1" x 8tpi
Order no: 610973 T38 M33 x 3.5mm
Order no: 200038
Our chucks are fitted as standard with the accessory mounting
jaws which are the key to fitting almost all other jaw options. You
will only need to remove the accessory mounting jaws to fit
external or internal Stepped Jaws or to carry out
cleaning and maintenance operations, for
information about Accessory Mounting Jaw
removal, see Maintenance
Section.
Order no: 610105
