Axminster Gyro Air G700, Manual

Page: 17 / 24

16
5. Operations
5.1 The operating and instructions of electrical components
（
Fig.13
）
A:
Power Switch: Connect or disconnect the power.
B:
Control panel:
Press the green button to start this machine, Press the red button to stop this
machine, turn the knob to adjust the frequency from 40Hz-75Hz.
NOTE:
1. Do not use the circled button as Fig.13. If you have operated the circled button, you must
power off this machine 10x’s, then power this machine again to restore the initial setup.
2. The panel may appear fault and alarm.
Failure code: dust processor will stop, after troubleshooting, press the button “OK” to cancel the
fault code display.
Alarm code: dust processor can run properly, you must power off and check it.
In majority cases, restart can eliminate the fault code and alarm code.
The common faults and alarm code as shown in the table below
:
Code type Code Name
Failure code
F1 Over-current
F2 Over-voltage
F3 under-voltage
F4 Inverter over temperature
F11 Motor over temperature
F85 Dust bin is full
Alarm code
A501 Current limit
A502 Over-voltage limit
A503 under-voltage limit
A504 Inverter over temperature
A511 motor over temperature
C. Buzzer: When the dust bin is full, the buzzer will sound
Fig.13