The pin chuck is a simple device which relies on
the cam action of a pin rolling on a flat machined
on the shaft to provide a secure grip for the
workpiece. All that is required is a 25mm hole
bored in the end of the timber; this is then slid onto
the pin chuck with the pin in position on the flat and
when the timber is rotated slightly the pin jams
between the flat and the timber and locks it firmly in
position on the chuck. The 5/8” diameter mounting
shaft will fit in the nose of the accessory mounting
jaws of the Super Precision, Woodturner’s or
Clubman K10 chucks.
20
Woodturning Chuck Jaws...
Order no: 400019 1MT Carrier for C Jaws
Order no: 400020 2MT Carrier for C Jaws
Order no: 800340 Pin Chuck 25mm
AXMINSTER
MORSE TAPER CARRIERS
Available in either 1 or 2 Morse taper, these carriers
fit into the C chuck jaws and enable drive centres
or arbors to be mounted without the need to
remove the chuck from the lathe. You could, of
course, purchase a carrier with a different taper
from that of your lathe, thereby extending the
range of usable centres.
AXMINSTER
PIN CHUCK
Chuck Accessories...
These jaws use eight conical rubber buttons to
securely pull back work onto the jaws. They are
intended for use with bowls up to 9" in diameter.
However, they may not be suitable for bowls
with very thin edges as the pressure may
deform the bowl edges.
The buttons are white rubber so as not to mark
the workpiece and are "dovetailed" to hold the
workpiece firmly against the plates.
AXMINSTER
BUTTON JAWS
Order no: 340956 Jaws 250mm
Order no: 340957 Jaws 400mm
