Order no: 810067 Spigot Jaws
These second generation spigot jaws have been designed to give
an improved grip when working with green wood. Similar in
operation to a pin chuck, the spigot jaws are inserted into a 30mm
diameter by 50mm deep hole in the blank and the jaws expanded
into the hole. It is important to use the full depth of the jaws in order
to give the best possible grip and to avoid over-stressing and
damaging the jaws. Should the grip loosen during turning then
another tweak on the key will soon restore it.
18
Woodturning Chuck Jaws...
150mm
WOOD JAW PLATES
A larger version of the wood jaw plates
giving scope for turning larger bowls.
The greater diameter of the plates gives
scope for larger wooden jaws which are
less prone to distort under the
tightening loads.
Order no: 910405 Wood Plate 150mm
100mm
WOOD JAW PLATES
A set of pre-drilled steel quadrants onto which
self-made wooden jaws can be mounted using
woodscrews. The wooden jaws can be used
for rechucking a bowl when removing a
dovetailed recess or spigot, or for producing a
variety of ‘jam’ chuck-type holding devices.
Order no: 910403 Wood Plate 100m m
Designed to give access around the
jaws for close-in tool work. With a deep
recess for holding long spigots and
giving rock solid mounting when turning
a long way from the headstock without
tailstock support. The jaws are also
dovetailed both inside and outside on
the lip. Three sizes are produced - the
size stated is the nominal bore of the
spigot recess.
AXMINSTER
O'DONNELL SPIGOT JAWS
Order no: 610356 25mm
Order no: 610357 38mm
Order no: 211354 50mm
AXMINSTER
Spigot Jaws
