- 16 -
Please Save This Manual For Future Reference
ASSEMBLY
Motor Cover
Install the door by inserting the pins of the door into the two
hinge socket on the cabinet.
(See Figure 1)
Extension Table
1. Attach a right hand extension table to the right or left side
of the table using three each Hex Head Bolt 10 x 25mm,
10mm lock washers and 10mm flat washers. Have an
assistant
hold the extension wing up to the table while inserting the
screws and washers. Finger-tighten only.
(See Figure 2)
Note:
If an assistant is not available, hold the wing in vertical
position up to the saw table, insert the middle screw and lock
washer finger tight, then pivot the wing to level position.
Insert the other two screws and washers finger tight.
2. Place the straightedge across the extension wings and
main table to make sure that the table surface is flat;
3. If the outside end of extension wings tilts down or up, use
a strip of masking tape to shim the extension wing up or
down ;(See Figure 3 and Figure 4)
Note:
Inspect the extension wings and main table mating
surfaces for burrs or foreign materials that may inhibit
assembly.
The mating edges of the wings and the table
must be clean and smootht. Use a wire brush or file if
necessary to clean up the edges.
Handwheel & Handle
Install each of the handles into the Blade Tilt & Height
handwheel and tighten with a 14mm wrench, thread the lock
knob into the center of the handwheel and tighten.
(See Figure 5)
Figure 1: Motor Cover Install
Figure 2: Extension Wings Install
Figure 3: Masking Tape Location For
Tilting The Extension Wing Up.
Figure 4: Masking Tape Location For
Tilting The Extension Wing Down
Figure 5: Handwheel Install
Lock Knob
Handle