Section 4
Assembly
4-1
WARNING
Observe all warnings and cautions provided
by the press manufacturer concerning press
operation to avoid serious personal injury and
possible damage to components.
1. Install the steering arm. Use Loctite
®
242 on
the screws. Install screws and tighten them to
200-258 lb-ft (271-350 Nm).
Installation
NOTE: Refer to Section 6 for drawings of the
tools specified in these procedures.
Hub Reducer
1. Apply Loctite 680 on the outer diameter of the
spindle ring. Install the spindle ring into the
end of the spindle.
2. Put one O’ring on the spindle.
3. Put the other O’ring in the groove of the
knuckle.
4. Apply a bead of silicone sealing compound
on the face of the spindle.
5. Use Loctite
®
242 on the screws. Tighten them
to 190 lb-ft (258 Nm).
6. Use a driver (part
number 5294) to insert a lightly greased
needle bearing into the spindle.
7. Use a seal driver (part number 5207) to
insert the seal.
8. Grease the lower edges of the seal.
9. Use Loctite
®
510 on spindle and fit seal race
after heating it to 210-250°F.
10. If the vehicle is equipped with central tire
inflation, follow steps A-C, below.
NOTE: Lightly lubricate the seal lips.
A. Install onto the hub the guide ring, the inner
seal use a seal driver (part number 5237).
B. Install the outside seal use a seal driver (part
number 5238) and the outside ring.
ISAS5 SEPTEMBER, 2017
