Axkid Minikid 3, Instruction Manual

Page: 19 / 192

19 19
EN
Restraining your child in
Axkid Minikid 3 car seat
Before restraining your child in the Axkid Minikid 3 car seat, make sure you have the correct inlay installed in the seat. Axkid Minikid 3 is
designed to grow with your child and to ensure a comfortable and safe fit for the children. Axkid recommends using the inlay until it is too
tight for your child, but to a minimum length according to table below (note that the age is just an indication):
Age Height
Toddler
0-3 years
61– 105 cm
61-105 cm
Child
3-7 years
106 – 125 cm
61-105 cm
The Axkid Minikid 3 is equipped with an automatic headrest (A) that will lower itself to the correct position when the harness is being tightened. To
ensure the best fit, Axkid recommends using this feature every time you restrain your child. Before placing your child in the car seat, ensure that the
automatic headrest (A) is in the unlocked position. See section headrest (A) adjustment for more information.
Make sure the Headrest brake lever (H) is set to unlocked. If locked, push the lever over to the unlocked position.
Loosen the harness by pressing the harness release button (E) and pull out both shoulder straps (R) at the same time.
Avoid pulling only one strap at the time since it may cause the shoulder straps (R) to become uneven. Make sure the
headrest (A) is pushed up to the top position.
Unlock the harness buckle by pressing the buckle release button (C) and place the straps outside of the seat.
Place your child in the seat and place the shoulder straps (R) over your child’s shoulder. Lock the harness by first
positioning the parts of the buckle that is attached to the shoulder straps (R) together and then push them into the
buckle until you hear a click.
Pull on the shoulder straps (R) to tighten the harness over your child’s hips. While keeping tension in the shoulder
straps (R), pull the harness tension strap (F) straight from the car seat until the harness is tightened enough, you should
not be able to fit more than one finger between the shoulder straps (R) and your child’s shoulders. While tensioning the
harness, the headrest (A) will automatically move downwards to the correct position for your child.