Axkid Minikid 3, Instruction Manual

Page: 21 / 192

21
EN
Care and maintenance
The seat textile cover can be machine washed at 30º C on a gentle cycle. Do not put the cover in a dryer as this can
damage the cover and the padding may separate from the fabric. Visit www.axkid.com to find videos explaining how to
remove and attach the cover.
Remove the textile cover:
• Remove the ASIP pad (I) if attached.
• Set the automatic headrest brake lever (H) to the unlocked position and loosen the harness by pressing the harness
release button (E) and pull out both shoulder straps (R) at the same time.
• Unzip the two zippers on the underside of the headrest (A) and carefully pull the cover off from the headrest (A).
• Lower the headrest (A) to the lowest position and switch the automatic headrest brake lever (H) to the locked position.
• Unlock the harness buckle by pressing the buckle release button (C) and remove the buckle cover.
• Unzip the zipper and open the belt clamp lid (O) and remove the plastic lid (O) from the textile cover.
• Unzip the zipper underneath the car seat and open the 4 buttons on the textile cover on the backside of the car seat.
• Unzip the two zippers at the backrest on the inside of the car seat and gently remove the textile cover from the car seat. Be
careful around the ASIP pad and other plastic covers not to damage the textile, don’t pull to hard.
• Open the shoulder pads and gently remove them from the Velcro.
Install the textile cover
• Reverse the steps from the instruction above to install the textile cover on the car seat again.
• Note that the shoulder pads can be installed at different positions. Install them in a position suitable for your child, the
shoulder pads should be positioned on top of the shoulder and on the chest of your child. Also make sure that the rubber
side of the shoulder pad is facing your child’s chest.
If the textile seat cover needs replacing, ensure only original products from Axkid are used. If other products are used, Axkid
Minikid 3 car seat’s safety system may be compromised and could lead to severe injury in case of an accident.
Any plastic parts of Axkid Minikid 3 car seat can be cleaned with mild detergent and water. Do not use aggressive chemicals
containing solvents or similar, as this can cause damage to the plastic and compromise the safety of the car seat.
Warranty
Axkid Minikid 3 car seat is covered by a 24-month warranty from date of purchase. Ensure you save your receipt and bring it to
your place of purchase if you have any warranty issues the warranty does not cover.
• Normal wear and tear
• Damage due to incorrect use, neglect, or accident
• If repairs have been carried out by a third party
• All materials used have a very high UV-resistance rating. However, UV-light is very aggressive and will ultimately lead to fad -
ing of the seat cover. This is not covered by our warranty as it is considered normal wear and tear.
• Handle the seat with care. Never carry the seat by holding in the headrest (A).