Axis P7214, Installation Manual

Page: 12 / 60

Page 10 AXIS P7214 Installation Guide
RS485/RS422 connector - Two 2-pin terminal blocks for RS485/RS422 serial interface used to
control auxiliary equipment, e.g. PTZ devices.
The RS485/RS422 serial port can be configured to support:
• Two-wire RS485 half duplex
• Four-wire RS485 full duplex
• Two-wire RS422 simplex
• Four-wire RS422 full duplex point to point communication
microSD memory card slot - The microSD memory card can be used for local recording with
removable storage.
BNC connector -
Connect a 75 ohm coaxial video cable (max. length 800 feet (250 meters)).
Note:
For each video input 75 Ohm video termination can be enabled/disabled via the product's web page at
Video & Audio > Video Input > Video termination. These terminations are enabled on factory default.
In cases where the product is to be connected in parallel with other equipment, for optimum video
quality, it is recommended that termination be enabled for only the last device in the video signal
chain.
LED indicators
Function Pin Notes
RS485/RS422 RX/TX A 1 (RX) For full duplex RS485/RS422
(RX/TX) For half duplex RS485
RS485/RS422 RX/TX B 2
RS485/RS422 TX A 3 (TX) For full duplex RS485/RS422
RS485/RS422 TX B 4
LED Color Indication
Network Green Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Unlit No network connection.
Status Green Steady green for normal operation.
Amber Steady during startup, during reset to factory default or when restoring settings.
Red Slow flash for failed upgrade.
Power Green Normal operation.
Amber Flashes green/amber during firmware upgrade.
RS-485/422 RS-485/422
RX/TX RX/TX
1 2 3 4
TX