AXIS 2100
User’s Guide
Choosing Your Application
19
Installation and Configuration Overview
Configure the AXIS 2100 to upload images to an Internet Service Provider in Alarm Mode as
follows:
Notes:
•By configuring the AXIS 2100 to accept incoming calls, you can at any time refine or amend the
product configuration remotely via a Dial-up connection - or locally, either from the Ethernet
network or via a computer connected via the supplied Null Modem Cable.
•You can refine your application using Web-based Administration Tools.
1. Connect the AXIS 2100 to the network if available. Otherwise, use the supplied
Null Modem Cable
.
2. Install the camera as a modem. For this and general information on the Dial-up connection, refer to
Using Your Camera
with a Modem,
on page 26.
3. Refine the Dial-up parameters.
4. Initiate the Dial-up connection.
5. Referring to
Configuring Your Camera,
on page 35, open the
Home Page
in your browser and start the
Installation
Wizard.
Complete the Wizard to
establish the standard
Security
,
Date and Time
,
Image
General Layout
and
Modem
settings
- selecting
modem
as your chosen method of connection.
6. Continue the configuration using the
Application Wizard
to define your preferred ISP and mode of operation -
choosing
Alarm Mode
to upload single images, or pre/post alarm image sequences, when a defined alarm or time based
event occurs.
7. Disconnect the camera from the network or Null Modem Cable and connect it directly to your modem.
8. Your application is now complete. You should now verify the configuration by triggering the defined alarm event and then
viewing the resultant images uploaded to your ISP.
