6
IV. PREPARING FOR INSTALLATION
Remove the outer packaging (wooden caging and/or carton box) and dispose it in
compliance with the laws in force in the country of installation.
REMOVING PROTECTIVE FILM ETC.
Remove the protection film from the external and internal walls. (See image)
Remove all information covering from the inside, and take off all plastic
packaging.
STAND ADJUSTMENT
Do not use the appliance without feet.
Inside the oven, there is a box with the legs (feet). Take the feet from the box and
screw them in the positions shown. They have threaded inserts (see image).
The legs give a gap that allows airflow and cooling the electric parts and outsides of
the oven. If they are not used, it will cause over-heating and damage to components.
The oven has to be installed on a flat surface. The unit must be leveled.
V. ELECTRICAL CONNECTION
WARNING: Mains connection must be carried out by a qualified and licensed technician or electrician
according to national, international and local laws in the country where it is installed.
Before mains connection, ensure that the frequency (…..Hz) and voltage (….V) meet the requirements
indicated in the in the information tag on the back of the appliance.
WARNING: It is advisable to connect it first then place it in position in the work area ensuring the cable is not
damaged during placement. This enables easy and safe connection. Ensure that the cable is uniformly
exposed to a room temperature no higher than 125F (50°C).
OVENS WITH CABLE AND SINGLE PHASE PLUGS
For appliance with cable and plug (single phase 220-240V) the plug merely needs to go into the
appropriate wall socket. The product must be positioned so that the plug is always accessible.
The appliance comes with certified cable and plug therefore they must not be tampered with or modified.
Only the cable can be substituted:
this must be carried out by a qualified authorized technician.
The earth
wire must always be yellow green.
APPLIANCE NOT SUPPLIED WITH CABLE WITH THREE PHASE TERMINALS
Ovens are supplied with terminals such as in the image. To connect to the mains see the label in the manual
and to the lower part of the back of the appliance near the Information Plate.
The oven must be connected to the electricity with a rubber cable such as Cab-Tire.
WARNING: the yellow/green voltage wires in the earth cable must be 1 ½”
(3cm) longer than the others.
The oven must be connected directly to the mains, dedicated circuit, and must have
an easily accessible switch. This switch must be installed according to the national,
international and local laws in the country where it is installed. This switch must
disconnect all poles guaranteeing complete disconnection in accordance with the
overvoltage III category.
Correct grounding is obligatory and the ground wire must not be operated by the
protection switch.
