AXIOMTEK OPS830 Series, User Manual

Page: 16 / 62

OPS830 Series User
’
s Manual
Introduction
10

Location of JAE TX25 Plug Connector
Please refer to the following drawing for location of the JAE TX25 plug connector.
Pin 1 of the connector is located at 114.8 mm from the edge of the module, and
106.9 mm from the inner side of the front panel. For mating tolerance of TX25 plug
connector and TX24 receptacle connector, please refer to the JAE specification

Vent Holes at the Pluggable Module Back Panel
On the OPS830 Module, it is recommended by Intel that some vent holes be opened
at the back so that hot air can escape more easily from the module that the FAR in
on both sides of the module back panel should be greater than 0.25.