Using the Graphic User Interface LABVIEW
28
CHAPTER 6
Using the Graphic User Interface of LabVIEW
6.1 Analog input function
Below figure is the IRU152 LabVIEW graphical user interface (GUI). The GUI can be
used to process the analog input of the IRU152.
6.1.1 The execution file is located at the following path:
C:\Axiomtek\LabVIEW SDK\IRUSeries\Binary\IRUSeries_AI_Read_Sample\IRUSer
ies_AI_Read_Sample.exe
6.1.2 Please input these parameters: IP Address, channel, rangeIndex, s ample
rate, trigger mode, trigger source, trigger c ondition, and trigger level.
6.1.3 Press Running.
6.1.4 The data graphics will be shown in waveform. The FFT graphic will be
shown in frequency domain. In the case below, sample rate is 1 kHz and the
source signal is 10hz.
6.2 Digital Input function
Below figure is the IRU152 LabVIEW graphical user interface. The GUI can be
used to process the digital input of IRU152.
Summary of Contents for IRU152-EVK-DC
