A795 User Guide: Programming Supplement
Chapter 2: Diagnostics and Configuration
13
*** A795 - Diagnostics Form ***
*** A795 - Diagnostics Form ***
Model number
: A795-2119
Serial number
: A014905324
Boot Firmware
Revision
: V3.07
CRC
: DF0D
P/N
: 189-1075274A
Flash Firmware
Revision
: V3.08
CRC
: ACE2
P/N
: 189-1075274A
H/W parameters
Flash Memory Size
: 1 Mbyte
Flash Logos/Fonts
: 384 kbytes
Flash User Storage
: 0 kbytes
SRAM : 256
kbytes
Head Setting
: D
Paper Type
: Kanzaki Red P-310RB
Paper Type Header
: 1.0aD
Print Density (Mono)
: 100 %
Max Speed
: 100 mm/sec
Paper Width
: 80 mm
Max Power
: 55 W
Knife
: Enabled
Partial Cut
: 155 steps
Paper Low Sensor
: Enabled
Comm. Interface
RX Buffer Size
: 4096
Interface type
: RS232/USB
Parameters
Baud Rate
: 115200
Data Bits
: 8
Stop Bit
: 1
Parity
: NONE
Flow Control
: DTR/DSR
Reception Errors
: Ignore
Alternate DTR/DSR : Disabled
Resident Code Pages
: 437, 850, 852, 858
860, 863, 865, 866
1252, 862, 737
Available Paper Types
: 0.0aD 1.0aD 5.0aD
To enter Printer Config Menu :
1) Flip DIP switch #1 down
2) Reset the printer, while holding
the Paper Feed button down
*********
*********
MAIN MENU
MAIN MENU
**********
**********
*******************************
*******************************
Select a sub-menu :
- EXIT
-> 1 click
- Print Current Configuration
-> 2 clicks
- Set Communication Interface
-> 3 clicks
- Set Diagnostics Modes
-> 4 clicks
- Set Emulation/Software Options -> 5 clicks
- Set Hardware Options
-> 9 clicks
Enter code, than hold Button DOWN
at least 1 second to validate
}
Current Printer tallies are
printed after the Diagnostic
information and will vary
per printer use.
For more information about
See this section
Accessing the remote diagnostic tallies
“Command descriptions” in Chapter 4: Programming Commands
(Status commands: Transmit printer ID, remote diagnostics extension,
Hexadecimal 1D 49 40 n)
Print test and configuration menu samples will vary per model or printer
configuration. (Shown approximately 60% of size.)
