3.3.4.
Found programmes
After a successful station scanning, the radio and TV stations are shown in the area "
FOUND PROGRAMS
".
The table contains information about programme type and encoding.
3.4.
Initialization phase 2
In the initialization phase 2, the found programmes are subdivided by tuner. The programme name, the
programme type and information about the encryption are shown.
After the station scanning in initialization phase 1 no assignment to a output modulator has been done. The
output channels of the modulators still have no programme.
All lines of the programme table have in the "Modulator" column four colored buttons M1 to M4. The buttons
correspond to the four modulators. The allocation of the buttons is given in the COLOR CODES legend.
You can assign programmes to modulators in
remux mode
or in
cross multiplex mode
.
Important:
With each programme you asign to an modulator, the data rate rises.
The performed modifications are only taken over by the system when you click the button
SAVE CHANGES
.
3.4.1.
Remux mode
If the transport stream IDs of the four modulators and the network ID are set on "auto", the module works in the
Remux mode. In this mode, the IDs from the set transponder and from the satellite are used and forwarded to the
modulators with virtually no changes.
Assigning programmes
Every tuner is assigned to a modulator. The programmes of the tuner can only be assigned to the associated
modulator.
Click onto the modulator button, the programme is assigned to the modulator.
For example click in table TUNER 1 on the button M1.
The programme is assigned to modulator 1.
The button of the modulator is highlighted in color
.
Chose the programmes for TUNER 1 to TUNER 4.
2016-10-31 | Technical changes, design modifications, errors and misprints are subject to change without prior notice.19
Choosen
programs for
modulator 1