Axent AXENT.ONE PLUS, User Manual

Page: 12 / 36

10
INTRODUCTION
REMOTE CONTROL
INTERFACE
User
Rear Wash
Massage Water Flow Position
Front Wash Dry Stop
System Purge
Descale
Setting
Light
Mute
Eco
When receiving remote control Command received and executed, the intelligent toilet will make
the following sounds:
One short «beep»
Command received and executed
Two short «beep» Command received but not executed
One long «beep» Remote control is not in range
TURNING ON
Install batteries to turn on remote control.
TURNING OFF
Remove batteries to turn off remote control.
BATTERY REPLACEMENT
When the power is low, the « Level Indicator » blinks which means the battery needs to be replace.
Please replace batteries. When replacing batteries, do not mix old and new batteries or batteries of
different brands or types.
PAIRING TO REMOTE CONTROL
This is only necessary when the remote control has been replaced.
Please make sure there is sufficient power supply for the remote control before pairing.
Unplug the intelligent toilet, wait for 30 seconds, and plug the power back in.
Stop
After three short «beeps», press «Stop» repeatedly within 20 seconds. The intelli-
gent toilet will emit three long «beeps» once the remote has been paired.