Axcera 6476B, Operation Manual

Page: 8 / 35

SYSTEM 6476B BROADBAND BOOSTER PAGE 2
CABINET MOUNTING INSTRUCTIONS FOR SLIDES DRAWING
CONNECTIONS
Once all equipment is in place, making connection to the back of the tray (s) is a
relatively simple process. Each wire is clearly marked with a number corresponding to
the tray where it connects.
NUMBERING
The numbering system used on wires that connect to the back of the trays is as
follows:
FIRST NUMBER - Channel designator
SECOND NUMBER - Connector on back of tray
EXAMPLE: A wire marked 2 10 would go to channel 2 in the group,
connector J10
Finally, verify that AC power (J1) is connected to each unit. Once this is complete,
proceed to the initial turn on procedures.
NOTE: All Axcera products are designed for operation with either 115VAC or
208/240VAC 50/60Hz input. Systems are shipped from the factory properly configured
for the standard of the country of destination.