Axcera-430B Type Acceptance Report
Test Report
February 2004
4-1
4. TEST REPORT
4.1 RF Power Measurements
Figure 4-1 shows the test equipment setup for the RF power measurements.
Figure 4-1. Test Equipment Setup for RF Power Measurements
The video modulation was adjusted for 25% with sync and blanking video signals and
the aural power was turned off. The power was then adjusted to obtain 600 watts of
average visual RF output (1000 watts peak sync at the output connector). This level was
used to establish a reference on the spectrum analyzer.
Next, the aural power was turned on and adjusted to 10 dB below the visual power. The
following operating parameters were recorded:
Peak Visual Power:/100%=1000 Watts Aural Power:/100%=100 Watts
continuous wave (CW)
Reflected Power:
<
1%
LO
Tektronix
TSG95
Video
Generator
Transmitter
Under Test
Bird
Model 43
Power
Meter
Bird
50 Ohm
Termination
Video
Input
RF
Output
Splitter
Tektronix 1350
Demodulator
IF Input
Tektronix VM700T
Video
Measurement
Test Set
Video
Narda
Directional
Coupler
TEK Sideband
Adapter
TEK
Spectrum
Analyzer
HP 8594E
Spectrum
Analyzer
RF
Summary of Contents for 430B
Page 58: ......
