AWT PIM-P, User Manual, Page: 99 / 110

12-8
PIM-P Analyzer User’s Manual
Copyright AWT-Global, LLC. All rights reserved.
• Read RSSI on PIM-P; value should be +/-1 dB of to Signal Generator’s Power level.
• Repeat the process you are no longer able to decrease the signal frequency F2
• Set PIM-P Signal frequencies F1 and F2 back to Start and End frequencies of PIM-P
band.
• Set Signal Generator to Frequency that results for IM3 product of frequencies F1
and F2
• Read the RSSI value on PIM-P; the value should be equal to +/-1 dB of the Signal
Generator’s Power level.
• Change the power level of the Signal Generator by 5dB. Never exceed -60dBm
• Read RSSI on PIM-P; value should be equal to +/-1 dB of the Signal Generator’s
Power level.
• Repeat until power level range of -60dBm to -120dBm has been covered
• Switch RF Signal of Signal Generator OFF
If the readings from the previously listed procedures deviate by more than +/- 1 dB,
contact your AWT Service.