AWT PIM-P, User Manual, Page: 55 / 110

7-29
PIM-P Analyzer User’s Manual
Copyright AWT-Global, LLC. All rights reserved.
F RF Power Button
Switches RF Power ON / OFF The Button inscription shows
what happens if the button is pushed. In the shown
screenshot RF power is OFF, the next button push will
switch RF power ON.
G Return
Brings PIM-P back to Field Mode. Works only when RF
Power is OFF
H Parameter Setting
To set power levels for the sweep cycles: Menu comes up
only with RF Power OFF
Note: frequency setting in the parameter menu is not relevant
for sweep measurements. Sweep Edit (P) sets frequency
ranges.
I Reference Line
Moves reference line for audible indication of measurements
that exceed the limit.
Same as Green/Red threshold of Bar graph in field mode.
Range -60 to -200 dBc
J Frequency
Graphic Display Frequency mode: IM signals shown as
vertical bar, indicating power and frequency. Signal colors
relate to numeric display
K Time
Graphic display – Time Mode: IM signals shown as moving
horizontal line, indicating power (changes) over time. Signal
color relates to numeric display
L Sweep
Graphic display Sweep mode. Signals are “swept” over a
range to test wide frequency range
M Hold
Hold Off blue, On red. While sweeping, measurement can be
held immediately.
N Single
Single Off –Blue, On -red. Determines if a single sweep or
continuous sweeps are measured.
O Sweep Edit
Opens Sweep Edit menu, allowing to set: End of Lower Tx
range, Start of Higher Tx range, Selection of measured IM
(in case more than one are in the range), sweep increment
time (default 100ms, range 10ms to 2000ms).
P Freq Up/Down
Only for visualization of Tx sweep ranges