PRODUCT DESCRIPTION
It is designed for operating under ambient temperatures b5
°C and +40 °C and for
installation at altitudes no more than 1000 m above M.S.L. The surrounding humidity should
be less than 50% at +40 °C. It can be stored or transported under ambient temperatures
between -25 °C and +55 °C.
Unpacking
At least two people are required to unpack the log splitter package. Take the following steps
to put the log splitter on the ground by tipping every side of the carton by 45 degrees. Make
sure to put block (B) to support the log splitter package (A) at the point a little higher than
the middle. The other side of block (B) shall be against a steady object, such as a wall.
Wedge (C) shall be arranged under the tipped log splitter package (A) every step to avoid
slipping. Then remove the carton off the log splitter.
Machine parts
1. Transport
handle
2. Ram travel adjusting rod
3. Split
wedge
4. Ram
5. Plug and switch
6. Top
motor
shield
7. Motor
8. Side bracket for support table
9. Wheels
10. Bleed screw
11. Base
12. Control lever guard
13. Adjustable log holder
14. Log holder adjusting knob
NOTICE! LOOSENING THE BLEED SCREW
Before operating the log splitter, the Bleed Screw should be loosened by some rotations until
air can go in and out of the oil tank smoothly. Air flow through the Bleed Screw hole should
be detectable during the log splitter is under operations. Before moving the log splitter,
make sure the Bleed Screw is tightened to avoid oil leaking from this point. Failed to loosen
the bleed screw will keep the sealed air in hydraulic system being compressed after being
decompressed. Such continuous air compression and decompression will blow out the seals
of the hydraulic system and cause permant damage to the log splitter.
