1 Installation Preparation
1.1 Basic Requirements
1.2 Installation Check
1.3 Cable Preparation
Make sure that the place where the Device is installed has enough space
to hold the Device and its mounting accessories.
For PTZ cameras, make sure that the place where the Device is installed
can sustain at least 4 times the weight of the Device and its mounting
accessories; for speed domes, make sure that the ceiling and wall can sustain 8
times the weight of the Device and its mounting accessories.
Do not install the Device at risky or unstable places.
Make sure that the wall is thick enough to install expansion bolts (Users
need to buy expansion bolts separately).
For speed domes support intelligent tracking, illegal parking capture or
laser, make sure that the mounting height is over 6m.
All installation and operations shall conform to your local electrical safety
regulations, fire protection regulations, and other relevant regulations.
Make sure that the application scenario conforms to installation
requirements. Contact your local retailer or customer service center if there is
any problem.
Use the Device according to the operating environment.
Keep the original packing material well because you might need it to pack
the Device and send it back for repair.
75 ohm.
Pure copper cored cables.
95% braided copper shielding.
For cables applicable to network devices and their maximum transmission
distance, see Table 1-1.
For cables applicable to
HD Analog
devices and their maximum
transmission distance, see Table 1-2.
1
Select the video cable depending on transmission distance.
1.3.1 Video Cable Requirements
