Page 4
Configure Your Light Tower Or Relay Switch
Configure Your Light Tower Or Relay Switch
Use Room Alert’s Built-In Web Interface
Navigate to
Settings
Alarms
in your Room Alert web interface. Both AVTECH’s Light
Tower and AVTECH’s Relay Switch may be configured on this page. The options you see
below will vary depending on your Room Alert model.
1. In
LTA Label
, you may leave the default, “Light Tower 1” or enter something more
descriptive of up to 15 characters. You may use the following characters in sensor
labels: letters, numbers, spaces, hyphens (-), underscores (_) and periods (.).
2. In
LTA Connected
, select your device from the drop-down list:
•
To configure a
Light Tower
, select either
Red/Green No Audio
or
Red/
Yellow/Green w/Audio
, depending on your model.
•
To configure a
Relay Switch
, select
Relay
.
3. Once you select your device, the
LTA Action Configuration
grid populates beneath it.
Here you may select
On
or
Off
from the drop-down list. (Note that the
LTA Relay
refers to the relay output port on the Light Tower & Relay Adapter.)
Light Tower
Relay Switch
4. Choose a profile from the drop-down menu to configure. The default is
Profile 1
.
•
Select
Profile X
to configure sets of on/off actions to associate with sensors when
they go in and out of an alarm state. The default for each feature is
Off
.
•
Select
Boot Profile
to configure what the Light Tower or Relay Switch does in
response to the Room Alert rebooting. The default for each feature is
Off
.