CONNECTION AND SETUP
6
For detailed PIN / port connection, please refer to “APPENDIX 2 PIN CONFIGURATION” at page 54. For DVR
setting to control the PTZ camera, please refer to “5.5.7 RECORD” at page 26. For detailed PTZ camera control
and operation, please refer to its own user manual.
RJ11 cable
RS485-A:
Red wire
RS485-B:
Green wire
The RJ11 cable is not supplied in the sales package.
9 PIN D-Sub Connector
25 PIN D-Sub Connector
RS485-A:
PIN 8
RS485-B:
PIN 9
RS485-A:
PIN 12
RS485-B:
PIN 24
1
15
16
17
18
19
20
21
22
23
24
25
14
2
3
4
5
6
7
8
9
10
11
12
13
Solder Side of
25-pin D-Sub connector
RS485 -A: PIN12 / RS485-B: PIN2 4
D-Sub connector is supplied with the DVR package.
STEP 1: Get a RJ11 cable with the proper length to your connection.
Different RJ11 connector may have different wire layout, so the connection might be different. If you
cannot control the DVR after connection, please reverse the RJ11 cable connection with the DVR.
STEP 2: Remove one end of the insulating coating of the RJ11 cable.
Remove one end of the insulating coating of the RJ11 cable to find the RS485-A and the RS485-B wires,
and remove the insulating coating to reveal the naked wires for further connection.
STEP 3: Twist the RS485-A and RS485-B wires of the RJ11 cable and the speed dome camera together.
Twist the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the RS485-A (brown) and
RS485-B (orange) wires of the speed dome camera. To protect the naked wires, use the insulation tape
to cover on the twisted wires.
STEP 4: Connect the other end of the RJ11 cable to DVR.
Solder the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the corresponding pins on the
solder side of the 9 or 25 PIN D-Sub connector (as shown above).
STEP 5: Set the speed dome camera at the DVR side.
Go to “ADVANCED CONFIG”
l
“DEVICES” to set the speed dome camera.
a) Select the device to “PTZ”.
b) Set the ID to the value the same as the one set in the speed dome camera. The default ID of the
camera is 000.
c) Select the protocol to “NORMAL”.
d) Set the baud rate to the value the same as the one set in the speed dome camera. The default baud
rate of the camera is 2400.
