INTRODUCTION
The AVB1-3 monocycle generator allows the generation of high-speed monocycle
waveforms, with peak-to-peak amplitudes of ≥ 50 V into 50Ω loads. The amplitude is not
adjustable.
The monocycle center frequency is adjustable over the range of 400 to 900 MHz. See
the online application note, "TB13 - How Is the Center Frequency of a Monocycle
Waveform Measured?" at http://www.avtechpulse.com/appnote/techbrief13/ for
information about center frequency measurements.
The AVB1-3 can operate at repetition rates of up to 100 kHz. An externally-generated
TTL-level signal is required to trigger the AVB1-3.
The AVB1-3 is powered by +15V DC.
The output is designed to drive 50Ω loads. (A 50Ω load is required for proper operation.)
The output is AC-coupled.
This instrument is intended for use in research, development, test and calibration
laboratories by qualified personnel.
AVAILABLE OPTIONS
The AVB1-3 is available with these options:
-AK1 Option: an accessory kit that consists of three SMA, 18 GHz, 2 Watt attenuators
(10, 20 & 30 dB) and two 50 Ohm, 1 GHz, 1 Watt feed-through terminators (one SMA,
one BNC).
-AK8 Option: an accessory kit that consists of one 12-inch SMA-M/SMA-M PE-
SR405FL coaxial cable, one 12-inch SMA-M/SMA-M RG-316 coaxial cable, one 36-inch
SMA-M/SMA-M RG-316 coaxial cable, one 24-inch SMA-M/BNC-M RG-316 coaxial
cable, one 36-inch BNC-M/BNC-M RG58C/U coaxial cable, one SMA-F to BNC-M
adapter, one SMA-M to BNC-F adapter, one SMA-F to SMA-F adapter, and one SMA-F
to solder cup adapter.
4
Summary of Contents for AVB1-3
Page 9: ...PERFORMANCE CHECK SHEET 9 ...