- 14 -
Output (Out1) is open (Out1 be Low voltage), two green wires will disconnect, the engine is then cut.
12.1 Output Control (Unlimited)
Command: W******,020,1,F
Description: Send this command to control the Output of VT300
Note:
F=0, to close the output (open drain);
F=1, to open the output (low voltage).
Example: W000000,020,1,1
Once the relay is properly installed, send this command to stop the engine.
12.2 Output Control (Limited)
Command: W******,120,F or W******,220,F
Description: Send this command to control the Output of VT300. This command is only workable when the
speed is below 10km/h(command 120) or 20km/h(command 220) and meantime GPS is available.
Note:
F=0, to close the output (open drain);
F=1, to open the output (low voltage).
Example:
W000000,120,1
W000000,220,1
Once the relay is properly installed, send this command to VT300. When its speed reaches at 10km/h or
20km/h, it will stop the engine.
13. Veer Report
Command: W******,036,degree
Description: when the heading direction of the tracker changes over the preset degree, a message with
location data will be sent back to the server by GPRS. This is to enhance the accuracy when the tracker make
a direction change.
Note:
degree=0, to turn off this function.
degree=[1,360], to set degree of direction change.
Example: W000000,036,90
When the tracker turns more than 90 degree, a message will be sent back to the server.
14. Initialization
Command: W******,990,099###
Description: This is to make all settings (except for the password) back to factory default.
Note: Turn on the device, press the SOS button for five times continuously and the red LED will be on, and
