Remote-Controlled Sensor Bypass
You can bypass the system sensor(s) at any time. The alarm system will still
provide full perimeter protection.
To Bypass the Sensor(s):
1. Press the remote TRUNK and OPTION buttons at the same time.
2. The siren will chirp twice. . . pause. . . chirp twice. . . pause . . . chirp
twice.
3. The sensor(s) is now bypassed until you remotely disarm and then re-arm
your system.
Previous Intrusion Alert
If the vehicle had been tampered with and the alarm has been triggered, the
siren will chirp 3 times upon remote disarm instead of the usual 1 chirp.
Specific Zone Intrusion Identification
If the alarm had been triggered in your absence, the siren will chirp 3 times
upon remote disarm (Previous Intrusion Alert). When you enter the vehicle
and turn the ignition "ON," the LED will flash in cycles to specifically identify
which zone has triggered the alarm.
LED
Zone
One Flash...One Flash...
Impact sensor
Two Flash...Two Flash...
Hood/trunk trigger
Three Flash...Three Flash...
Door trigger
User-Programmable Door Ajar Indication
When you remotely arm the alarm system and a door is ajar (not closed), the
siren will chirp 2 times, then chirp 3 times and the parking lights will flash 3
times. This feature provides audible and visual indication to prevent battery
drain. (See "Programming Table for System Features" on page 11.)
NOTE: If your vehicle has factory delayed lighting, this feature will be
turned off.
8
Phoenix
2
Rev. A - Owner's Manual 0399
