To Deactivate Remote-Controlled Valet
1. Press the remote ARM/DISARM and SILENT buttons at the same time.
2. The parking lights will flash 3 times.
3. The LED will turn off to indicate the alarm is no longer in
Remote-Controlled Valet.
Keyless Entry in Valet Mode
While the system is in the Valet mode, you can still use your remote control to
lock and unlock the doors as well as activate any optional accessory such as
trunk release or remote engine starter.
LED System Status Indicator
The LED on your vehicle’s dashboard or center console will inform you of the
system status.
LED
Status
Off
System is disarmed
On solid
In a valet mode
Slow flash
System is armed
Flashing in cycles
See "Specific Zone Intrusion Identification"
on page 8
Rapid flash
Passive arming
Remote-Controlled Accessory Outputs
These outputs allow you to add optional remote-controlled accessories to your
system such as a remote engine starter, trunk release, window roll-up, garage
door opener or fuel door release. To activate your optional accessories, see
the "Programming Table for Remote Controls" on page 12.
Zone
2
™ Impact Sensor
The Zone
2
Impact Sensor has two individual vibration/impact sensing zones.
Zone #1
If a less threatening vibration or impact is detected, the siren will issue 2
warn-away chirps. A second violation will also issue 2 warn-away chirps. If
within 45 seconds a third violation is detected, the sensor will automatically
trigger the alarm. The siren will sound and the lights will flash.
Zone #2
If a more threatening vibration or impact is detected at any time, the siren and
lights will activate instantly.
7
Phoenix
2
Rev. A - Owner's Manual 0399
