Avital AVISTART 4501, Installation Manual

Page: 15 / 28

Heater/AC #1 — Heater/AC #2
The satellite relay module has one onboard 30-amp relay. Most vehicles have
only one heater/AC wire. If an additional heater/AC wire is required to activate
the vehicle’s heater/AC system, follow the directions under step #5 on the page
12. Do not use the
GRAY wire to power more than one heater/AC wire.
1. Use a voltmeter to find the wire(s) that show +12 volts when the ignition
key is in the "ON" position, 0 volts while the starter is cranking and +12
volts while running.
2 . Cut this wire in half. Start the vehicle and turn the blower switch on. The
blower should not turn on.
3. Connect the GRAY wire to the heater/AC wire.
4. If the vehicle has a second heater/AC wire, connect the PINK/BLACK wire
to the second heater/AC wire.
5 . Selectable ignition or heater/AC output #2– the PINK/BLACK wire can be
programmed to supply an ignition or heater/AC output. The satellite
module is factory programmed for ignition #2. To change the
PINK/BLACK wire from ignition to heater/AC, follow the procedure below.
• Open the satellite relay module (2 screws).
• Remove the jumper terminal from "IGN2" terminal.
• Insert the jumper terminal to the "ACC2" terminal.
Starter
I WARNING : Review the "Safety Bulletin" and diagrams on pages
11-13 prior to installing the starter system.
1 . Use a voltmeter to find the wire that shows +12 volts while the ignition
key is in the "CRANK" position only and 0 volts while the key is in the
"OFF," "ON" and "RUN" positions.
2. Cut the wire in half. Test by trying to crank the starter with the ignition
key. If it will not crank, you have the correct wire.
3 . Connect the YELLOW wire to the ignition switch side of the starter wire.
4. Connect the VIOLET wire to the starter solenoid side of the starter wire.
Door Lock/Unlock
The system has onboard door lock relays to lock and unlock all of the doors as
well as a two-stage unlock. The diagrams on pages 17-20 will illustrate
standard lock/unlock and two-stage unlock.
13
AviStart 4501 Installation Manual - 0999