Valet Switch
1. Discuss placement with the owner.
2. Choose a location for the valet switch that is hidden, but convenient for
the owner to access.
3. Drill a ¼" hole and mount the switch.
4. Route the valet switch wires to the control unit.
5. Plug the valet switch WHITE connector into the control unit WHITE
plug.
LED In di ca tor
1. Discuss placement with the owner.
2. Choose a location that is visible from both sides of the vehicle.
3. Drill a ¼" hole.
4. Route the LED wires through the hole and press LED into place.
5. Route the LED wires to the control unit.
6. Plug the RED LED connector into the control unit RED plug.
Ig ni tion In put
1. Use a voltmeter to locate the one wire that shows +12 volts when the
ignition key is in the "ON," "CRANK" and "RUN" position, and 0 volts
when the ignition key is in the "OFF" position.
2. Connect the control unit PINK wire to the vehicle’s ignition wire.
Chan nel 2 Ac ces sory Out put
The DARK BLUE wire provides a 0.75 second ground (-) output when
activated for 1-2 seconds. If the remote control button is continually pressed,
the signal will stay at ground as long as the button is held. Most trunk
releases are positive and require an optional relay.
Chan nel 4 Ac ces sory Out put
The LIGHT BLUE wire provides a 0.75 second ground output when
activated for 1-2 seconds. If the remote control buttons 1 & 2 are continually
pressed, the signal will stay at ground as long as the buttons are pressed.
This output can be used for optional accessories such as remote start,
window roll-up/down or any other accessory requiring a (-) accessory
activation.
7
Hurricane
2
/AMX78 (2) Installation Manual
