Required Installation Tools
Voltmeter
Wire Strippers
Electric Drill & Bits
Phillips Screw Driver
Convoluted Tubing *
Solder Gun *
Wire Crimpers
Shrink Tube *
Electrical Tape
* Optional
Important Information
1. Test all circuits with a voltmeter.
2. Make all wiring connections with the supplied solderless crimp
connectors. DO NOT twist wires or use “scotch-lok” connectors.
3. Route RED, RED/WHITE and BLACK wires from the control unit
directly to the battery.
4. Keep extensions as short as possible. Use same gauge wires for short
extensions and larger gauge wires for longer extensions.
5. Before installing, discuss the placement of the LED indicator and valet
switch with the vehicle owner.
6. Make all battery connections by removing the bolts from the cable
clamps. DO NOT disconnect the battery cables.
7. Turn off dome light or remove dome light fuse to prevent battery drain.
8. Making secure connections is a very important part of your installation.
Solderless crimp connectors are supplied in your hardware accessory
package. This type of connection is sufficient for most of your
installation. However, soldering of the starter disable wires is
recommended whenever possible. For a more secure installation, solder
all of your connections and insulate with heat shrink tubing.
This de vice com plies with Part 15 of the FCC rules. Any changes or
modi fi ca tions made to the sys tem with out the ex press ap proval of Avi tal
Tech nolo gies, Inc. could void the user's author ity to op er ate this equip ment.
3
Hurricane
2
/AMX78 (2) Installation Manual
