43
© 2008 Directed Electronics. All rights reserved.
ledflasHes
sHutdownmode
1
System timed out
2
Over-rev shutdown
3
Low or no RPM, Low battery (for voltage &
virtual tach modes)
4
Transmitter Shutdown (or optional push button)
5
(-) hood shutdown
6
(+) brake shutdown
7
Neutral safety
Safety check
Before vehicle reassembly, the remote system must be checked to en-
sure safe and trouble-free operation. The following test procedure must
be used to verify proper installation and operation of the system. The
installation must be completed before testing, including connection to
the brake switch and hood switch.
1. Test the BRAKE shutdown circuit: With the vehicle in Park (P), ac-
tivate the remote start system. Once the engine is running, press
the brake pedal. The engine should shut down immediately. If the
engine continues to run, check the brake circuit connection.
2. Test the HOOD PIN shutdown circuit: With the vehicle in Park
(P), open the hood. Activate the remote start system. The vehicle
should not start. If the starter engages, check your hood pin and
connections.
Note:
If programmed for Diesel Mode, the system will turn on the igni-
tion, but the starter should not engage with the hood open.
3. Test the NEUTRAL SAFETY shutdown circuit:
