Mounting the Control Panel Case
Follow the steps below to mount the control panel case.
1. At the installation site, remove the control panel case from the LifeSafety Power FlexPower box.
2. Find two studs in the wall where the enclosure should be installed.
NOTE:
In a finished setup, the enclosure and contents together weighs 17.7kg (39lb).
3. Mount the plywood board onto the wall at the desired location.
NOTE:
It is highly recommended that the plywood board is mounted to two studs. If no studs are
available, use appropriate drywall anchors that can support the enclosure.
4. Remove one of the two high voltage knockouts.
5. Attach an appropriate cable gland to the 7/8” diameter high voltage opening.
6. Mount the enclosure to plywood using six wood screws.
High voltage knockouts
Screwholes
Low voltage knockouts
Mounting the Control Panel Case
7
