Setup the B100 Power Supply Board
On the B100 board, ensure Output Voltage Selection jumper (JP3) is set to position 1 for 12VDC out, as shown
below.
See the B100 Quick Start Manual or B100 Installation Manual for more detail (available at
http://www.lifesafetypower.com/docs/im_b100.pdf
) .
Setup the D8P Power Supply Board
On the D8P board, set all output voltage selection jumpers (JP1 to 8) to provide 12VDC.
See the D8 Quick Start Manual or D8/D8P Installation Manual for more detail (available at
http://www.lifesafetypower.com/docs/im_d8.pdf
).
CAUTION —
Failure to set the JP1 to 8 jumpers may cause damage to components.
Setup the B100 Power Supply Board
12
