![Avidyne DFC90 Pilot'S Manual Download Page 51](http://html.mh-extra.com/html/avidyne/dfc90/dfc90_pilots-manual_3031511051.webp)
Approach Procedures
4-9
PROCEDURE TURN ILS OR LOCALIZERS
The procedure for an ILS or Localizer with a procedure turn in a
combined DFC90/430 system is the same as the straight-in
procedures except that Heading mode should be used on the
procedure turn. This is accomplished by press
ing the “HDG”
button on the autopilot control panel and then using the heading
knob on the PFD. Command the heading bug to the outbound
procedure turn heading. Hold that heading until the point at
which it is time to turn inbound. Use the heading knob to select
the inbound procedure turn heading, being careful to turn the
heading knob in the same direction you wish the aircraft to turn.
When established on the front inbound procedure turn heading,
arm the NAV APPR modes by simultaneously pressing the “HDG”
button and the “NAV” or “APPR” button.
If equipped with a combined DFC90/GNS430W (or GTN) set of
equipment and if the procedure turn is activated in the GPS Nav-
Com, then the autopilot can be flown in GPSS mode by pressing
the “GPSS” button on the autopilot control panel. In this case, the
aircraft will automatically fly the outbound procedure turn heading,
automatically make the turn inbound to the inbound procedure
turn heading and then fly that inbound procedure turn heading.
The pilot is still
responsible for manually pressing the “APPR” (or
“NAV”) button on the autopilot control panel when established on
the front inbound localizer course. In this case, Primary Nav must
be ensured/set to VLOC.
Change 3