AXP340 Transponder Installation Manual
10 March 2014
01201-00
Issue AF
Page 14
AVIDYNE CORPORATION
GPS Model
Protocol Used
Baud Rate
96 / 96C
NMEA 0183
9600
Aera 510/795/796
NMEA 0183
9600
GNC 250(XL)
NMEA 0183
9600
GNS 480
Aviation
9600
GNS 4x0
Aviation
9600
GNS 5x0
Aviation
9600
GPS 150(XL)
NMEA 0183
9600
GPS 16X
NMEA 0183
9600
GPSMAP 295/495/496/695/696
NMEA 0183
9600
GTN650
Aviation
9600
GTN650
Garmin ADSB
9600
GTN750
Aviation
9600
GTN750
Garmin ADSB
9600
The interface speed can be selected between 4800, 9600, 19200, 38400 and 57600 bps.
Some of the protocols listed above may not contain all the required data for a compliant ADS-B message,
depending on the intended airspace regulations. For further information refer to Section 11 (ADS-B
Compliance) of this manual.
5.6 Molex Crimp Terminals
The Molex connector contacts should be wired with wire of 18-24 AWG. The contacts are compatible with
a wide range of crimp tools. Ensure that the contact has been crimped using both the conductor crimp and
the insulator crimp.
Once crimped, the contacts should be slotted into the rear of the connector shell. Push the contact in until
the retaining tab clicks into place. Tug gently to confirm the contact is locked in place.
The contacts can be easily removed using the Molex removal tool, or equivalent. This is pushed gently into
the connector shell from the side opposite from the wire entry, and lifts the retaining tab from the stop,
allowing the contact to be eased out by pulling on the wire.
