Avid Technology SR2400, Setup Manual, Page: 75 / 90

Checking the Drivers
75
17. Click Next. The Network Settings screen appears.
18. Click the Typical radio button. The network settings are site dependent
and will be set later during the PortServer configuration.
19. Click Next. The Workgroup and Computer Domain screen appears.
20. Click No. The workgroup and domain settings are site dependent and will
be set later during the PortServer configuration. The Performing Final
Tasks screen appears, followed by the Complete the Windows 2000 Setup
Wizard screen.
21. Click Finish. The Windows 2000 operating system is loaded.
22. Click the Start button, and select Shut Down. The Shut Down Windows
dialog box opens.
23. Select the Shut down option, and click OK. The Windows 2000 operating
system shuts down and turns off the PortServer system.
24. Reconnect all of the Ethernet network cables.
25. Boot the PortServer system.
Checking the Drivers
You need to check the versions of the ATTO and Alacritech drivers to make
sure you have the correct drivers for the version of MediaNetwork software
you are using.
To check the ATTO drivers:
1. Locate the ATTO driver version number you wrote down at the end of the
operating system recovery procedure.
2. Locate the MediaNetwork CD-ROM for the version of MediaNetwork
software you are going to reinstall.
3. Insert the MediaNetwork CD-ROM into the PortServer CD-ROM drive.
4. Navigate to Drivers_Firmware\HostBusAdapters\ATTO\ Drivers\Win2k.
5. Right-click the EXPRESFC.SYS file, and select Properties. The
EXPRESFC.SYS Properties dialog box opens.
6. Click the Version tab. The version information appears.
7. Compare the “File version” in the dialog box to the version you wrote
down at the end of the operating system recovery procedure, and do one
of the following: