AVG-HD350A
3. Product Appearance of the AVG-HD350A
Transmitter
①
Power LED:
The LED illuminates red when power is applied.
②
Test Pattern:
Press the button with paper clip or other sharp tool to enable the
test pattern, and the left LED illuminates blue, the product generates an image of
1080P/60Hz color bar to output; Press this button again, the left LED blinks blue
at an interval of 500ms, the product generates an image of 4K/60Hz 4:4:4 color
bar to output. Press and hold this button for three seconds again can exit the Test
Pattern mode.
③
1080P
→ 4K:
Press the button with paper clip or other sharp tool to enable 1080P
to 4K up-scaling, and then the left LED illuminates blue. Press it again to exit.
④
EDID:
4-pin DIP switch for EDID setting and HDCP mode selection. Please refer
for more details.
⑤
FW:
Micro-USB port for firmware upgrade and user-defined EDID upload.
⑥
HDMI In:
Type-A female HDMI input port to connect a HDMI source.
⑦
ARC Audio Out:
Toslink connector to connect speaker or amplifier for ARC audio
output.
⑧
IR In:
3.5mm jack to connect the IR receiver for IR pass-through.
⑨
IR Out:
3.5mm jack to connect the IR emitter for IR pass-through.
⑩
RS232:
3-pin terminal block to connect the RS232 control device (e.g. PC) or a
third-party device to be controlled.
⑪
HDBT Out:
RJ45 port to connect the HDBT input port of receiver by CATx
Ethernet cable. The LINK LED illuminates orange when there is a valid HDBaseT
link between the transmitter and the receiver. The HDCP LED illuminates green
when the video contains HDCP content.
⑫
DC 24V:
DC connector for the power adapter connection.
Tx
Rx
LINK
HDCP
1
2
3
4
5
6
7
8
9
10
11
12
HDBT Out
HDMI In
IR Out
IR In
ARC Audio Out
