AVG-CS4K-88
Command
Function
Feedback Example
System Commands
/*Type;
Query the models information.
XXXXX
/%Lock;
Lock the front panel buttons on the Matrix.
System Locked!
/%Unlock;
Unlock the front panel buttons on the Matrix.
System Unlock!
/^Version;
Query the version of firmware
VX.X.X
Demo.
Switch to the “demo” mode, switch input and
output in sequence e.g. 1B1, 1B
2, …4B3, 4B4,
1B1
… and so on. The switching interval is 2
seconds.
Demo Mode
AV:01->01
IR:01->01
AV:01->02
IR:01->02
……
AV:08->08
IR:07->07
……
Operation Commands
[x]All.
Route signal from the input channel [x] to all
output channels
X To All. (X=01~08)
All#.
Route all input signals to the corresponding
output channels respectively like 1->1, 2->2
…
All Through.
All$.
Switch off all the output channels.
All Closed.
[x]#.
Route signals from the input channel [x] to the
output channel [x].
X Through. (X=01~08)
[x]$.
Switch off the output channel [x].
X Closed. (X=01~08)
[x]@.
Switch on the output channel [x].
X Open. (X=01~08)
All@.
Switch on all output channels.
All Open.
[x1]V[x2].
Route the AV signal from the input channel [x1]
to one or several output channels ([x2],
separate output channels with comma).
AV: X1-> X2
(X1/X2=01~08)
[x1]B[x2].
Route the AV and IR signal from input channel
[x1] to one or several output channels ([x2],
separate output channels with a comma).
AV: X1-> X2
(X1/X2=01~08)
[x1]R[x2].
Route the IR signal from output [x1] to input
[x2].
IR: X1-> X2(X1
、
X2=01~08)
Status[x].
Check the I/O connection status of output [x]
AV: Y-> X
(X=01~08, Y=01~08)
Status.
Query the input channel to each output channel
one by one.
AV: 01->01
… …
AV: 08->08
IR: 01->01
… …
IR: 08->08
Save[Y].
Save the present operation to the preset
command [Y], range is from 0 to 9.
Save To FY (Y=0-9)
Recall[Y].
Recall the preset command [Y].
Recall From FY (Y=0-9)
Clear[Y].
Clear the preset command [Y].
Clear FY (Y=0-9)
PWON.
Work in
‘normal’ mode.
PWON
PWOFF.
Enter into standby mode and cut off the power
supply to HDBaseT receivers.
PWOFF
STANDBY.
Enter into standby mode. (Do not cut off the
power supply to HDBaseT receivers, press any
button or send commands to start.)
STANDBY
