AVG-CS4K-88
5.2 IR Control
5.2.1 IR Remote
Connect a 5V IR receiver to the
IR Control
port of the Matrix Switcher, users can
control it through the included IR remote. Here is a brief introduction to the IR
remote.
①
Standby button:
Press it to enter/ exit standby mode.
②
INPUTS:
Input channel selection buttons, range from 1~8.
③
OUTPUTS:
Output channel selection buttons, range from 1~8.
④
Menu buttons:
ALL
: Select all outputs.
EDID
management button: Enable input port
to manually capture and learn the EDID data
of output devices.
CLEAR:
Withdraw an operation like switching
output channel, learning EDID data before it
comes into effect. Meanwhile, the matrix will
return to the previous status.
ENTER:
Confirm operation.
By using IR & HDBaseT transmission technology, the 4K HDBaseT Matrix Switcher
has some functions as follows:
1)
Control a far-end output device from local.
2)
Control local input/output device remotely.
3)
Control the Matrix Switcher locally/remotely.
5.2.2 Force Carrier
a)
Only if the 5V IR receiver connected to the HDBaseT receiver has an IR carrier,
can the received IR signal be transferred to the IR OUT port of the Matrix
Switcher.
b)
Only if the 5V IR receiver connected to the Matrix Switcher has an IR carrier, can
the received IR signal be transferred to the IR OUT port of the Matrix Switcher.
If the 5V IR receiver connected to HDBaseT receiver or the Matrix Switcher is
without an IR carrier signal, send the RS232
command “%0901.” to enter infrared
carrier enforcing mode, and then the IR signal will be enabled to the IR OUT
ports.
INPUTS
OUTPUTS
MENU
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
ALL
EDID
CLEAR
ENTER
1
2
3
4
