34
EZ-TOUCH-M Revision 4
4 INSTALLATION
The EZ Ethernet Option Card (P/N EZ-ETHERNET) comes with two different
type screws. Remove the screws from the packaging and set aside.
a.
Connect EZTouch Panel to a computer and, following instructions in
EZTouch Panel Software Help Topics or User Manual, upload the user
program from the Panel to the computer. Save the user program to
disk.
b.
Disconnect panel power source.
c.
Open back cover (shown open in figure to
the right) to install the card.
d.
The connector on the bottom right side of
the card installs into the backplane
connector.
e.
Secure the card into place by installing the
two screws.
f.
The bottom of the plastic back cover has a
section that must be removed to allow access to the EZ Ethernet
connector that extends over the edge of the board. To remove this
plastic section, look for the perforation and snap it out along the
performation with a pair of pliers.
g.
Close rear cover and press so that it snaps into place.
h.
Reconnect power source, connect to PC, run EZTouch Programming
Software and follow instructions to download the user program
previously saved to disk.
i.
Consult the EZ Ethernet Option Card Manual (P/N EZ-ETHERNET-M)
for programming instructions.
EZ Ethernet Option Card
DO NOT FORCE THE
CARD CONNECTOR
into the backplane —
to do so may bend or
break the pins and
permanently damage
the card. First, ensure
that the pins are
aligned properly, and
then press firmly into
place.
BACKPLANE
LEDs
Connector
DIP Switches
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
