EZ-TOUCH-M Revision 4
27
4 INSTALLATION
METHOD 2. DIN Clips
EZ-S6M-R, EZ-S6M-F, EZ-S6M-FH, EZ-S6C-K, EZ-S6C-F, EZ-S6C-FH DIN Clip Slot Location
The 6-inch Slim Bezel models must be mounted using DIN Clips
.
It is
optional for the other 6-inch models. DIN Clips are metal brackets (P/N EZ-
BRK-1, package of 2 brackets and 4 screws) that attach to the panel and
secure the front panel to a mounting surface with 4 screws. Use the diagram
and instructions below to mount the EZTouch Panel using DIN Clips.
1.
There are 4 rectangular holes in each side (two at the top and two at
the bottom) of the chassis as shown in the following figure. Choose
the holes that allow the appropriate space for your mounting panel
thickness.
2.
On each DIN Clip there are two metal tabs (bent inward) that fit into
these holes. Insert the two clip tabs into two holes (top and bottom)
and secure the panel by alternately tightening the DIN Clip screws (4)
until the back edge of the EZTouch Panel front bezel is flush with the
mounting panel.
CAUTION: Tighten DIN Clips to a maximum of 1.5 inch-pounds to pro-
vide a proper seal. Automationdirect.com assumes no responsibility for
“liquids” damage to the unit or other equipment within the enclosure
because of improper installation.
CAUTION
Front Bezel
Mounting Panel
DIN Clip location
Screws (4)
DIN Clip tab inserted into rectangular
hole closest to the front bezel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
